<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: System Administration—Cluster

To open the system administration, select Setup | System Administration from the main menu bar. Select the various tabs to change the different settings.

System Administration Bar

System Administration Bar

You can define the following aspects of your PRTG system setup:

In the cluster settings, you can define the cluster settings. During failover cluster configuration, the cluster settings were already predefined. See the cluster status to see if all cluster nodes are properly connected.

icon-prtg-on-demandThis feature is not available in PRTG hosted by Paessler.

icon-prtg-on-premisesIf you use PRTG on premises and open the system administration page from another administration page, PRTG asks you to enter your credentials again for security reasons if 15 minutes (900 seconds) have passed since your last credential-based login. A dialog box appears. Enter your Login Name and Password for PRTG in the corresponding fields and confirm to continue.

Cluster Settings

icon-i-roundThis documentation refers to the PRTG System Administrator user accessing the PRTG web interface on a master node. If you use other user accounts, interfaces, or failover nodes, you might not see all of the options in the way described here. If you use a cluster installation, note that failover nodes are read-only by default.

You can set up two, three, four, or five cluster nodes for PRTG on premises. In the table of the cluster settings, the information of each cluster node is written in one line.

Cluster Node Setup

Node Name

Enter the name of the cluster node (for display purposes).

Node ID

The ID is unique for every cluster node. We recommend that you use the default value.

Node State

Set the state for every failover node:

  • Active: Set the failover node to be active.
  • Inactive: Set the failover node to be inactive. It is then disabled in the cluster configuration. It is then not an active part of the cluster and does not appear in the cluster status anymore.

icon-i-roundThis setting is not available for the master node of a cluster. The master is always set to Active.

IPs/DNS Names Used for Connections Between Nodes

Define the IP addresses or Domain Name System (DNS) names that are used for the connections between the cluster nodes. You can enter different values for every node–node connection.

For example, in the field #2 => #1, enter the address under which the master node server can be reached from the second cluster node. Usually, this is the IP address or DNS name of the master node. Do this for all available cluster node connections, for example, if you run three cluster nodes, enter the address under which the second cluster node can be reached from the third cluster node into the field #3 => #2.

icon-book-arrowsSee also section Failover Cluster Step by Step, Step 4 and following.

icon-i-round-redIf you use remote probes outside your local network or outside your network address translation (NAT), ensure that the IP addresses or DNS names you enter here are valid for both the cluster nodes to reach each other and for remote probes to reach all cluster nodes individually. These addresses must not be private and have to be reachable from the outside, otherwise your remote probes are not able to connect.

icon-i-round-redSave your settings. If you change tabs or use the main menu, all changes to the settings are lost.

icon-book-arrowsFor how to set a cluster node into Maintenance Mode, see section PRTG Status—Cluster Status.

icon-book-arrowsThe entire setup process for a cluster requires several different steps. For more information and step-by-step guidance, see section Failover Cluster Configuration.

 

Others

There are some settings that you must make in the PRTG Administration Tool, available as native Windows application. For more details, see the sections:

Keywords: Cluster Connection,Configure,Configure Cluster